Rakitan pipa air pendingin
Kode OE / Material
13253857-00SC2E-8101280Selanjutnya:
- Tinjau pilihan Anda di halaman keranjang.
- Bayar langsung lewat Stripe (jika semua item ber-harga retail).
- Atau kirim daftar sebagai penawaran untuk diskon grosir.
Spesifikasi Teknis
- Model Kendaraan
- BYD Atto 3
- Konfigurasi Kemudi
- Universal (Setir Kiri & Kanan)
- Kategori
- Radiator & Pendingin
Pengiriman & Pengembalian
Dikirim ke seluruh dunia dari Tiongkok melalui pengiriman udara atau laut. Pengiriman standar 5–30 hari kerja, ekspres 2–10 hari kerja. Biaya pengiriman dihitung saat checkout.
Jendela pengembalian 7 hari untuk barang yang belum digunakan dalam kemasan asli. Hubungi kami sebelum mengembalikan barang apa pun.
Kendaraan yang Kompatibel — Rakitan pipa air pendingin
Rakitan pipa air pendingin Panduan Bengkel — BYD Atto 3
Cooling Water Pipe Assembly - Removal and Installation
Removal
- Power off the high voltage electrical system. See Power-off and power-on of high voltage electrical system
- Discharge coolant. See Replacement of Coolant
- Loosen 2 fixing clamps, and remove the cooling water pipe assembly.
Installation
- The installation steps are opposite to the removal steps.
- After the installation, fill in the coolant. See Replacement of Coolant
Caution After installation, check the pipeline joints to make sure there is no leakage. If any, the inspection and repair shall be carried out again.
Cooling Pipe Assembly 1 - Removal and Installation
Removal
- Discharge coolant. See Replacement of Coolant
- Remove the front motor lower mudguard assembly. See Front Motor Lower Mudguard Assembly - Removal and Installation
- Detach the 2 pipe clamps.
- Remove the cooling pipe assembly 1.
- Loosen 1 fixing clamp, and detach the cooling pipe assembly 1 from the integrated intelligent front drive assembly.
- Pry up a hold-open catch, and take out the cooling pipe assembly 1.
Installation
- The installation steps are opposite to the removal steps.
Caution After installation, check the pipeline joints to make sure there is no leakage. If any, the inspection and repair shall be carried out again.
Cooling Pipe Assembly 2 - Removal and Installation
Removal
- Discharge coolant. See Replacement of Coolant
- Loosen 2 fixing clamps, detach the cooling pipe assembly 2 from the electric water pump assembly I and the integrated intelligent
front drive assembly, and take it out.
Installation
- The installation steps are opposite to the removal steps.
Caution After installation, check the pipeline joints to make sure there is no leakage. If any, the inspection and repair shall be carried out again.
Rakitan pipa air pendingin Diagram Pemasangan — BYD Atto 3
Komponen lain dalam rakitan ini
