Оригинал
BYD Atto 3
наружная ручка правой задней двери в сборе
OE / Каталожные коды
13168425-00SA3F-6205109DЦена по запросуВ наличии
Технические характеристики
- Модель
- BYD Atto 3
- Конфигурация рулевого
- Универсальный (LHD и RHD)
- Категория
- Двери и багажники
Доставка и возврат
Доставка по всему миру из Китая авиа или морем. Стандартная доставка 5–30 рабочих дней, экспресс 2–10 рабочих дней. Стоимость рассчитывается на оформлении заказа.
7-дневный возврат для неиспользованных товаров в оригинальной упаковке. Свяжитесь с нами до отправки возврата.
Совместимые автомобили — наружная ручка правой задней двери в сборе
BYDYuan PLUS/Atto 3
2022–2025наружная ручка правой задней двери в сборе Руководство по ремонту — BYD Atto 3
Right Rear Door Outer Handle Assembly - Removal and Installation
Removal
- Lift the right rear door glass to the limit position.
- Remove the right rear door sealing plug I. See Right Rear Door Sealing Plug I - Removal and Installation
- Take out 1 screw cover, and loosen 1 fixing screw of the right rear door outer handle assembly.
- Pull the outer handle, and take out the plug.
- Detach the outer handle gasket.
- Unlock the right rear door outer handle assembly.
- Press the locking mechanism by hand.
- And turn the unlocking mechanism over at the same time.
- Take out the right rear door outer handle assembly.
- Remove 1 fixing screw of the right rear door outer handle seat assembly.
- Remove the right rear door outer handle seat assembly.
- Detach 1 fixing clip, and detach the right rear door lock outward-opening lever from the right rear door outer handle seat assembly.
- Take out the right rear door outer handle seat assembly.
Installation
- The installation steps are opposite to the removal steps.
Right Rear Door Handle Box Cover - Removal and Installation
Removal
- Pry up the right rear door handle box cover.
Caution Be careful when removing the trim panel to avoid scratching the surface material.
Installation
- The installation steps are opposite to the removal steps.
Right Rear Door Snap Handle Ambient Light Assembly - Removal and Installation
Removal
- Remove the right rear door guard board assembly. Right Rear Door Guard Assembly - Removal and Installation
- Remove the right rear door snap handle ambient light control module.
- Disconnect 1 connectors.
- Remove 2 fixing screws, and take out the right rear door snap handle ambient light control module.
- Remove the right rear door inner snap handle assembly.
- Detach 1 fixing clip.
- Remove 3 fixing screws, and take out the right rear door inner snap handle assembly.
- Remove 2 fixing screws, and put aside the right rear tweeter horn.
- Remove 1 fixing screws.
- Pry up the right rear door inner snap handle seat and the handle.
- Remove 2 fixing screws, and take out the right door inner snap handle inner plate.
- Take out the right rear door inner snap handle ambient light and the tweeter horn.
Install
- The installation is performed in reverse order of removal.
