узел пряжки левого заднего ремня безопасности
OE / Каталожные коды
13465326-00SC2EM-5812070Технические характеристики
- Модель
- BYD Atto 3
- Конфигурация рулевого
- LHD и RHD
- Категория
- Сиденья и ремни
Доставка и возврат
Доставка по всему миру из Китая авиа или морем. Стандартная доставка 5–30 рабочих дней, экспресс 2–10 рабочих дней. Стоимость рассчитывается на оформлении заказа.
7-дневный возврат для неиспользованных товаров в оригинальной упаковке. Свяжитесь с нами до отправки возврата.
Совместимые автомобили — узел пряжки левого заднего ремня безопасности
узел пряжки левого заднего ремня безопасности Руководство по ремонту — BYD Atto 3
Left Rear Seat Belt Buckle Assembly - Removal and Installation
Removal
- Remove the left rear seat cushion assembly. See Left Rear Seat Cushion Assembly - Removal and Installation
- Disconnect 1 connector of the left rear seat belt buckle assembly.
- Detach 1 wiring harness clip of the left rear seat belt buckle assembly.
- Remove 1 fixing bolt from it, and take out the left rear seat belt buckle assembly.
Installation
- The installation steps are opposite to the removal steps.
Left Rear Seat Belt Assembly - Removal and Installation
Removal
- Remove the left C-pillar upper guard assembly. See Left C-Pillar Upper Guard Assembly - Removal and Installation
- Remove 1 fixing bolt from the left rear seat belt assembly.
- Disconnect 1 connector of the left rear seat belt assembly.
- Remove the left rear seat belt assembly.
- Remove 1 fixing bolt.
- Remove 1 fixing bolt, and take out the left rear seat belt assembly.
Caution When disconnecting the connector, insert the small screwdriver wrapped with tape into the connector slot to pry up the striker, and then pull out the connector.
Installation
- The installation steps are opposite to the removal steps.
Caution After installation, check whether the seat belt is installed in place to ensure that there is no distortion or seizure.
Right Rear Seat Belt Buckle Assembly - Removal and Installation
Removal
- Remove the left rear seat cushion assembly. See Left Rear Seat Cushion Assembly - Removal and Installation
- Disconnect 1 connector of the right rear seat belt buckle assembly.
- Detach the wiring harness clip from the right rear seat belt buckle assembly.
- Remove 1 fixing bolt from it, and take out the right rear seat belt buckle assembly.
Installation
- The installation steps are opposite to the removal steps.
узел пряжки левого заднего ремня безопасности Схема установки — BYD Atto 3
