OrisinilPremium
BYD Atto 3
Rakitan panel trim kiri spoiler
Kode OE / Material
13222057-00SC2E-5614130$27USD
TersediaSpesifikasi Teknis
- Model Kendaraan
- BYD Atto 3
- Konfigurasi Kemudi
- Universal (Setir Kiri & Kanan)
- Kategori
- Komponen Bodi Eksterior
Pengiriman & Pengembalian
Dikirim ke seluruh dunia dari Tiongkok melalui pengiriman udara atau laut. Pengiriman standar 5–30 hari kerja, ekspres 2–10 hari kerja. Biaya pengiriman dihitung saat checkout.
Jendela pengembalian 7 hari untuk barang yang belum digunakan dalam kemasan asli. Hubungi kami sebelum mengembalikan barang apa pun.
Kendaraan yang Kompatibel — Rakitan panel trim kiri spoiler
BYDYuan PLUS/Atto 3
2022–2025Rakitan panel trim kiri spoiler Panduan Bengkel — BYD Atto 3
Spoiler Left Trim Panel Assembly - Removal and Installation
Removal
- Power off the low voltage electrical system. See Power-off and Power-on of Low Voltage Electrical System
- Remove the tailgate upper guard assembly. See Tailgate Upper Guard Assembly - Removal and Installation
- Disconnect the wiring harness of spoiler assembly.
- Disconnect 1 connector.
- Detach the rear wash line sub-assembly IV from the rear wash line sub-assembly III.
- Detach 2 silicon seals.
- Remove 4 rubber covers from the tailgate.
- Remove the fasteners from the spoiler assembly and its accessories.
- Remove 6 fixing screws.
- Remove 6 fixing bolt.
- Pry up the spoiler assembly and its accessories.
- Remove 4 fixing screws, and take out the left spoiler trim panel assembly.
Installation
- The installation steps are opposite to the removal steps.
Instrument Panel Left Trim Panel Assembly - Removal and Installation
Removal
- Pry up the instrument panel left trim panel assembly.
Caution Be careful when removing the trim panel to avoid scratching the surface material.
Installation
- The installation steps are opposite to the removal steps.
Instrument Panel Left Trim Panel Assembly - Removal and Installation
Removal
- Remove the instrument panel left end guard assembly. See Left Shield Assembly of Instrument Panel - Removal and Installation
- Remove the lower fixing plate of PAD mounting base guard. See Lower Fixing Plate of PAD Mounting Base Guard - Removal and Installation
- Remove the console body assembly. See Console Body Assembly - Removal and Installation
- Remove one fixing screw.
- Detach 17 fixing clips, and take out the instrument panel left trim panel assembly.
Installation
- Follow the removal steps in reverse order to install.
